European standard power cord, three-phase plug product descripti

Product introduction of three-phase plug power cord with European standard

       European standard power cords are wires that transmit current. The three-phase plug of the European standard power cord, the current is usually transmitted a point-to-point manner. Power cords can be divided into AC and DC power cords according to their use. European standard power cords are usually AC power c that are wires with higher voltage AC, and these wires need to be certified as safe according to a unified standard before they can be officially produced. However, DC wires are basically through lower voltage DC, so the safety requirements are not as strict as AC wires, but for safety reasons, countries still require unified safety certification. For household appliances, although European standard cords are just accessories, they play a vital role in the use of household appliances. If the power cord is broken, the entire appliance cannot be used. Household power c should use BVV2 × 2.5 and BVV2 × 1.5 models of wire. BVV is the national standard code, European standard power cords are sheathed wires, 2 × 2.5 and 2 × 1.5 respectively represent 2 cores of 2.5 square millimeters and 2 of 1.5 square millimeters. Generally speaking, 2 × 2.5 is used as the main line and trunk line, 2 × 1.5 used as the branch line and switch line of a single appliance. The single-phase air conditioner special line uses BVV2 × 4, and a special ground wire is also.

Application description of European standard power cord

       These European standard power cables are mainly intended for use in water at depths of up to 10 m, with a maximum temperature of 40C for the three-phase plug, for the connection of equipment such as submersible pumps or similar devices. They must not be used for the transmission of electricity under water or installation in a waterway, or for use in an environment where mechanical damage may occur and could cause harm. Indirect burial is permitted where there is mechanical protection. These European standard cables are manufactured in accordance with standard CEI20-19/16. It is the only European standard power cable that may be installed in swimming pools and fount under the provisions of CEI64-8, section 702. As a connecting cable for moderately mechanical equipment, it can be used for equipment in industrial or agricultural, large boilers, heating plates, electric tools:

Such as drill bits, circular saws, electrical appliances, portable motors and generators for construction, can also be laid along the ground or scaffolding at temporary work point, and can also be used for the connection of lifting equipment, etc., is fully protected in a fixed installation (i.e. in a pipeline or equipment with a working voltage of up to 1000 V, three-phase plug can also be used for the connection between the motor and the rotor of the lifting equipment. European standard power cords have the characteristics of ozone resistance, UV resistance and weather resistance.